Port Forwarding - Beetel 440TX

Now for those of you who have just upgraded from the beetel 220BX to the 440TX, this is a small, handy tutorial.
If if you download a lot, you obviously use utorrent/azureus/any other bit torrent client.
Im am going to save myself the tedium of mentioning why port forwarding is so necessary . You'll find ample reasons here.

Now for those who have switched from the 220bx, you will have to forward the ports on your 440tx once again. The address 192.168.1.1/main.html does not hold good here. Instead use this http://192.168.1.1/html/index1.html.

On entering this you should see a page similar to this


The default username is "admin" and password is "password" or "123456". If this does not work, call up the customer care and they will guide you.
Once you log in you must see a screen similar to this



As shown in the image, on the top of the page click the "Advanced" link.
You will be take to this page



On this page click on the link titled "Port Forwarding", as shown in the image.
This will take you to this page.
If you get a message asking you to specify an ip address before proceeding, do this. Click on "LAN Clients -->Select LAN Connection should be LAN Group1 --> Under Enter IP Address, enter your own ip address. (You can find out your ip address by going to command prompt and entering the command "ipconfig") -->Click on "Apply". Now click on "Port forwarding".



On this page select the "user" radio button and click on the "New" button as indicated.
You will be taken to this page.



Under rule name you can give any name, for example, i entered utorrent. Under protocol select TCP,UDP.
Under "port start" enter the first port number you wish to open and "port end" specifies the ending port number. The "port map" should contain the same port number as what you entered in "port start".
As an example i opened up a single port, 61132 for utorrent.



Once this is done click on apply and go back to the previous page.
Now check the "user" radio button, you should now be able to see the newly created rule.
Select the rule, click on "Add" and click on "Apply".

Now on the top of the page click on "Tools", you will be directed to this page. Then click on "System Commands"



On the page click on "Save All" and then click on "Restart". Your modem will reboot.



Your done.
Do post a comment if you need any further assistance.